Skip to main content

Battery Replacement and Charging Guide

This guide provides step-by-step instructions for safely replacing and charging batteries in your smart devices.

Battery rotation helps ensure consistent device performance. In case of battery discharge, remove the used batteries, insert fully charged replacements, and recharge the used ones for reuse—either in the same or other compatible smart devices.

This process is especially useful during seasonal transitions, such as when moving from off-season to on-season (e.g., returning cabinets from warehouse to retail outlets). Before the start of the on-season, clients are encouraged to fully charge all smart devices to ensure uninterrupted functionality.

What's included in the initial shipment:
Battery Recoupe Pack with a spare set of 20 batteries.

Replacement Steps​

Open the Battery Lid​

  1. Locate the four screws on the battery lid.
  2. Use a screwdriver to open the screws.
  3. Carefully remove the battery lid.
Battery Lid ScrewsRemoved Battery Lid

Image showing the location of the screws and the removed battery lid.

Remove the Battery​

  1. Use a plastic pry tool to gently disconnect the battery.
  2. Carefully lift the battery out of its compartment.
Battery Lid ScrewsRemoved Battery Lid

Images demonstrating how to use the plastic pry tool to remove the battery.

Charge the Battery​

  1. Use a compatible charger (as shown below) to charge the battery.
  2. Charge the battery until it reaches 3.85V or more. Further on this in precautions.
Battery Lid ScrewsRemoved Battery Lid

Images showing the charger and the battery being charged.

Reinstall the Battery​

  1. Before placing the battery back, ensure the polarity is correct.
  2. Match the battery polarity with the markings on the PCB.
  3. Gently insert the battery into its compartment and make sure it is securely in place.
  4. Screw back all the screws to secure the battery lid.
Battery Lid ScrewsRemoved Battery Lid

Images showing the correct polarity alignment and the final reassembled device.

Battery Replacement Tutorial link - Battery Replacement Tutorial

Precautions​

  1. Always use a plastic pry tool to avoid damaging the battery or device.
  2. Double-check the polarity to prevent any short circuits.
  3. Ensure all screws are tightly secured after reassembly.
Battery charging threshold
  • During Air travel: battery should not be charged above 70%
  • if battery is 2500 mAh - 3.85v
  • if battery is 3000 mAh - 4.0v
  • if no air travel then full charge - 4.2v